SIDES and FLOOR:
1/4" Floor & 10 ga. 50,000 yield steel sides with formed top rail.
Fully welded 10 ga. taper box type side braces, inside corners
chamfered 45 degrees at floor and full length sloping rub rails to
shed material for safe, positive cleaning.
TAILGATE:
Hi-tensile steel with formed top rail. Boxed reinforcements and
sloping lower brace.
TAILGATE HARDWARE:
Upper is fabricated steel weldment with oversize pin. Lower hook
engages tailgate pin from top. Keyhole eye keeps tailgate in position.
APRON:
1/4" Steel 30" long x full width with fixed side plates.
UNDERSTRUCTURE:
Welded 3" structural channel cross members and 5" x 2" x 1/4" box
type longitudinals, fully gusseted.
CAPACITY:
10 cu. yd. bed dimensions are 84" inside x 144" long with 40" high
walls, 46" high tailgate, pockets provided for side boards.
CONTROLS:
Hoist, rotation and tailgate actuator functions are controlled by
12 VDC solenoid valves activated by cab mounted toggle switches.
SAFETY FEATURES:
Hoist is restricted to 45 degree dump angle by 12 VDC limit switch.
Tailgate automatically opens when dump angle exceeds 22.5 degrees;
two-hand control is required to override this feature. A safety strut
is provided for use when servicing unit.
MAINTENANCE FEATURES:
Mechanism consists of no linkage or moving parts other than main
bearings and hydraulic cylinders. No special tools are required for
service. Contact surfaces on cylinder pins have grease ways which are
ported to a bank of grease fittings which are reached from ground
level without moving the unit.
ROTATING SUBFRAME & HOIST:
|
Maximum Lifting Capacity: |
60,000 lbs. |
|
Subframe: |
Heavy Duty Wide Flange |
|
Hoist Speed: |
50 Secs. to 45 degrees |
|
Mounting Height: |
14" |
|
Dump Angle: |
45 Degrees |
|
Hoist Cylinder: |
Telescoping (3 Stage Single Acting) |
|
Hoist Cylinder Bore/Stroke: |
5-4-3 x 104 |
|
Turning Speed: |
1/2 RPM |
|
Swing Actuator: |
Hydraulic Cylinders |
|
Thrust Bearing: |
Diameter -- 43"
Max. Moment Load -- 120,000 ft./lbs. |
|
Hydraulic Valves: |
Manifold |
HYDRAULIC REQUIREMENTS:
|
Power Source: |
pto/pump combination |
| System Requirements: |
21 gpm at 2,000psi |
|
Reservoir Capacity: |
30 Gal. (minimum) |
|
NOTE: The two return lines
from a ROTO 180 must be routed directly to the tank and must NOT
be combined or manifolded with each other or with other equipment. |
